[CLOSED] 3D: MVC file not created

Post Reply
DAE avatar
arrgh
Posts: 49
Joined: Wed Jun 24, 2020 4:51 pm

[CLOSED] 3D: MVC file not created

Post by arrgh »

recent version does not create the MVC-file, only the .264
User avatar
Rocky
Posts: 3555
Joined: Fri Sep 06, 2019 12:57 pm

Re: 3D: MVC file not created

Post by Rocky »

Did you wait for the demux operation to fully complete? For example, if your disk has a single M2TS, the MVC stream will not be created until after the base stream is fully demuxed. Don't just start the demux and expect both files to be created immediately. If you deselect the base stream the MVC stream should be created right away.

BTW, I have 3D planes parsing working and will release soon. I can't release it until this issue is resolved.
DAE avatar
arrgh
Posts: 49
Joined: Wed Jun 24, 2020 4:51 pm

Re: 3D: MVC file not created

Post by arrgh »

I demuxed with the GUI; I have just chosen the videostreams, nothing else; the process was finished (no green "Cyclon Eye" in the left downside-corner) and there was just the .264 file in the folder...
I will re-do it and report...
User avatar
Rocky
Posts: 3555
Joined: Fri Sep 06, 2019 12:57 pm

Re: 3D: MVC file not created

Post by Rocky »

arrgh wrote:
Thu Aug 06, 2020 4:04 pm
no green "Cyclon Eye" in the left downside-corner
When you get the finished.wav sounding and all the controls re-enabled, then things are done. I have tested with no problems.
DAE avatar
arrgh
Posts: 49
Joined: Wed Jun 24, 2020 4:51 pm

Re: 3D: MVC file not created

Post by arrgh »

:oops:
...sorry it failed several times reproduceably (without further notice) until it crossed my mind to check the disc...
cleaned it with water and soap... now it runs through...
maybe I should stopp using my discs as Pizza plates...

again: sorry for the false alarm...
Post Reply