[RESOLVED] Bad delay values for audio demuxed from bluray with a range set
Re: [RESOLVED] Bad delay values for audio demuxed from bluray with a range set
It's not just trimmed streams. For example, an off-air capture will be the same way. Streams like this are why you need to find a correct delay in the first place. If you limit things to streams that are already zero delay, there's no need to try to determine it.
Re: [RESOLVED] Bad delay values for audio demuxed from bluray with a range set
Coming a bit late to the party...
I also agreee that checking with eyes and ears is the only reliable method.
I've seen too much mastering anomalies such as different audio formats on the same PID over m2ts in a mpls, no Audio in a m2ts etc.
I've written some checks I perform wirh Mediainfo in batch files to get some basic info of the processed source.
Afterwards I always check the muxed file for A/V sync.
ggtop
I also agreee that checking with eyes and ears is the only reliable method.
I've seen too much mastering anomalies such as different audio formats on the same PID over m2ts in a mpls, no Audio in a m2ts etc.
I've written some checks I perform wirh Mediainfo in batch files to get some basic info of the processed source.
Afterwards I always check the muxed file for A/V sync.
ggtop
Re: [RESOLVED] Bad delay values for audio demuxed from bluray with a range set
Hi,
just wanted to reply on the weird issue I reported. I finally found out that the demuxed audio stream has an issue at around position 00:01:57h.
That was reported by TSMuxer on attempting to mux a Bluray folder from the original source. I used EAC3to to insert a silent frame at that position and now evrything is fine.
BTW All the tools I know didn't report an issue at that timestamp.
ggtop
just wanted to reply on the weird issue I reported. I finally found out that the demuxed audio stream has an issue at around position 00:01:57h.
That was reported by TSMuxer on attempting to mux a Bluray folder from the original source. I used EAC3to to insert a silent frame at that position and now evrything is fine.
BTW All the tools I know didn't report an issue at that timestamp.
ggtop